I need instructions/wiring diagram to install a set of noisless pickups model 0992115000. Any ideas?

Unless you are doing something fancy, they install just like any other pickups. All black leads go to ground, white leads (neck and middle) go to the appropriate switch terminals, yellow (bridge) goes to it's terminal.

You can wire them up just like this:

http://support.fender.com/service_diagr ... A_SISD.pdf

_________________
Bill

There is a difference between these and normal single coils, because regular single coils have 2 conductor wires, and noiseless have 4, because they're actually humbuckers, so the have a wire for each coil.
Go to
dimario.com, click on any of their noiseless single coils, like anArea 61 for example, then click download installation instructions.

Or go to seymourduncan.com, they have wiring diagrams for everything.
REMEMBER THOUGH, the color of the wires will probably be different, so you need to know what the different wires are on your guitar.

Howdy!

The link Bill posted will work fine for your set of Fender Vintage Noiseless.


Although Fender Vintage & Hot Noiseless are stacked, single coil sized humbuckers they only have two wires. One hot (+) and one ground (-)

The Seymour Duncan and DiMarzio websites will not have wiring diagrams for Fender Vintage Noiseless pups.

Andy

_________________
Pending Greatness

Fender Vintage (the kind the OP is asking about) and Hot Noiseless pickups are only two conductor. SCN and N3 Noiseless are three conductor. No Fender pickup that I know of is four conductor. As a "professional", I would have expected you to know this.

_________________
Bill

This is correct, my US Deluxe came from Fender with the "Vintage Noiseless" pickups installed and they have two wires same as a normal Single Coil. The Bridge pickup has the Yellow wire.

Snowy