Is it simple to dismantle a stratocaster standard USA?

Are there sites with photos which can help me?

Very easy, you can have one striped down to parade rest(sorry former military)
in less that 1 hour. As far as a video, check youtube.

_________________

A couple of things to remember...

- Loosen the trem springs before you start messing with the bridge.
- The pickup assembly ground may be soldered to the trem claw.
- Lay all the peices out nice and neat, put screws in plastic bags.
- Watch for falling shims & trem bar springs.
- If you like the way it's set-up now, take measurements before you start.
- To get the bridge springs back on install the end that attaches to the bridge block then thread a small screw driver through the eye at the claw end, put tip of screw driver against claw spring tabs and lever springs into place.
- Take note of any markings that are written on the heel of the neck or body cavaties, you'll probably find date marks.

_________________
Tune Low, Play Hard & Floor it!