I wanted to put SDs on my Deluxe Strat. I looked everywhere for a wiring diagram. I finally called them. Included is the instruction from Brandon at SD

****

Fender S-1 Switching (for Standard 3-pickup Strat)
To put one or more Seymour Duncan humbuckers (full or ‘lil sized) into a Standard 3-pickup Strat with the S-1 switching system:



For the BRIDGE pickup:

Put the Duncan GREEN wire to the 5-way switch where the original PU's red wire went.

Put the Duncan RED & WHITE together (solder them together and tape them off).

Put the Duncan BLACK wire to the S-1 switch where the original PU's black wire went.

Put the Duncan silver (bare, non-insulated) wire to ground on the bottom of the volume pot.



For the MIDDLE pickup:

Put the Duncan GREEN wire to the S-1 switch where the original PU's yellow wire went.

Put the Duncan RED & WHITE wires together (solder them together and tape them off).

Put the Duncan BLACK & BARE wires to ground on the bottom of the volume pot.



For the NECK pickup:

Put the Duncan GREEN wire to the 5-way switch where the original PU's white wire went.

Put the Duncan RED & WHITE wires together (solder them together and tape them off).

Put the Duncan BLACK wire to the S-1 switch where the original PUs black wire went.Put the Duncan silver (bare, non-insulated) wire to ground on the bottom of the volume pot.

****


Craig



[img]<a href="http://www.flickr.com/photos/22895449@N04/3639886894/" title="Deluxe w SDs close by Knotty Hotman, on Flickr"><img src="http://farm3.static.flickr.com/2437/3639886894_772a140c4a_b.jpg" width="769" height="1024" alt="Deluxe w SDs close" /></a>
[/img]