Fender® Forums

Page 1 of 1

Author:  Glentortolano [ Sun Apr 21, 2019 6:28 am ]
Post subject:  Woofer


One of the woofers has blown.

Can someone give me the specs I need to put a replacement in?

Ohms ? Watts?

Thanks for your help


Author:  stratele52 [ Mon Apr 22, 2019 2:30 am ]
Post subject:  Re: Woofer

Put a picture of the woofer, anything is write on ?

Author:  Glentortolano [ Mon Apr 22, 2019 2:38 am ]
Post subject:  Re: Woofer

They don’t have writing on them ? It just says 6.5inch woofer ??

Author:  stratele52 [ Mon Apr 22, 2019 2:53 am ]
Post subject:  Re: Woofer

Are you sure woofer is blow ?

By the size of the magnet and impedance you may find a replacement here (?)


Or write to Fender Consumer relation , scroll down here

Author:  ContraCaller [ Mon Aug 12, 2019 6:30 am ]
Post subject:  Re: Woofer

The Expo has two subwoofer speakers in each cabinet. Are they both dead or distorted or just one of them? Are you sure that the 6.5" speaker is blown, or could it be that the power amp built into the speaker cabinet that drives the subwoofer may be fried? Have you done any testing to isolate the problem?

Since the Expo is a "powered speaker", that means that the cabinet includes a power amp for the subwoofer, a power amp for the low-mid, a power amp for the high-mid, and a power amp for the tweeter, and crossover circuitry to split the input signal to the different power amps (or it has two crossover circuits -- one to split between the bass amp and the main amp, and one to split the output from the main amp among the low-mid, high-mid, and tweeter -- I'm not sure which way this was designed...).

In other words, it's not just a speaker cabinet. It's kinda complex. This might not be something you can fix with a solder gun and no testing. You really need to isolate the problem before you know for sure which component needs replacing.

Page 1 of 1 All times are UTC - 7 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group